- 3 year in home warranty
- Polycarbonate composite construction
- Fully reversible for summer & winter
- 3 speed wall control with light switch included
Cruise 50″ Ceiling Fan
$0.00
The Cruise ceiling fan is the perfect edition to your decor with its simplistic and chic design and powerful yet efficient 50W motor.
Rotational Diameter
50" (1250mm)
Blade Material
Polycarbonate Composite Construction
Blade Pitch
11°
Motor Wattage
50W
Motor Type
AC Motor
Controller Type
3 speed wall control with light switch
Summer / Winter Reverse
Yes
Installation Location
Indoor Only
Speed
1 Speed | 2 Speed | 3 Speed
Current
0.165A | 0.142A | 0.121A
Power
40W | 28.2W | 18.5W
Warranty Period
3 year In home warranty
Warranty Application Form
The below documents are required to apply for a warranty claim for your Martec product. These documents can be submitted at the end of the below form.
1. A copy of the Installation Receipt OR Tax Invoice OR Certificate of Compliance for the installation of the Martec product from the installing electrician.
2. Copy of the Purchase Receipt/Tax Invoice
3. The below form completed in full with as much detail as possible. Please also include pictures of the products if possible.
How Does Ripple Control Affect LED Lights?
A flickering LED light is the most common complaint arising from ripple control, which is generated when usually but not only when the light is dimmed and the ripple control frequency is in the line, usually between 300Hz and 1300Hz.
The Flickr is often, but not always, intermittent depending on when the ripple control signals are being transmitted. It is normally at certain times i.e. 6 pm and then again at 8:30 pm and will only last for 30 seconds to 2 minutes, and when the power company stops sending the signal the flicker stops.
People often notice it most acutely in the night when off-peak hot water systems are turned on. ALL brands of LED drivers are affected by these ripple control signals.
Why Doesn’t Martec have Ripple Control Filters in their LED Drivers?
Ripple control is not the norm and in many environments. While Martec does sympathise with the few customers who do experience a problem, it is not cost effective to build an Electronic Driver that rejects all ripple control frequencies given the small proportion of people affected, a cost that would have to ultimately be borne by all customers.
